| Step 1: Lay the F 1047A,
-1047B-L, and - 1047B-R J - Stiffeners back in place in the notches of
the frames and bulkheads as shown in Figure 1. |
|
Step 2: Cleco the F 1075
Aft Top Skin in place.
Using the rivets called out on Page 10-26,
Figure 1, rivet the aft top skin to the three F 1047 J Stiffeners and to
the F 1008 & 1009 Frames. When riveting to the frames, rivet from the
center of the skins out to the sides. Do Not rivet the skin to the F
1007 Frame. It will be riveted to the frame, along with the F 1074
Forward Top Skin, when the tailcone is attached to the forward Fuselage.
Rivet the sides of the aft top skin to the F-1073 Side Skins and the
underlying F-1032 Longerons using the rivets called out on Page
10-25, Figure 1. Do not rivet the front corner holes in the aft top skin
which are common to the F-1007 Frame. |
|
| Step 3: Attach the F-635
Elevator Bellcrank to the F-1037A Bellcrank Angles using the hardware
called out in Figure 2. |
|
| Step 4: Bolt the two
F-1037A Bellcrank Angles to the F-1035 Battery / Bellcrank Mount
using the hardware shown in Figure 3. |
|
| Step 5: Attach the
F-1035 Battery / Bellcrank Mount to the F-1037B & C Bellcrank Rib Angles
using the hardware shown in Figure 3. Do not secure the fasteners in
this step completely, the battery / Bellcrank mount will have to be
removed later. |
|
