|
RV BUILDER NET .COM
|
| 09.04 Elevators |
|
||||||||||||||||||||||||
| Step : 1 Cleco the E-910
Hinge Reinforcement Plates to both E-1002 Front Spars, as shown in
Figure1, then final-drill all the 1/8" holes common to the spars and
plates using a #30 drill.
Mark the plates so they can be reinstalled in the same position. Remove the plates from the spars and set them aside. 05/04/08 |
 |
||||||||||||||||||||||||
| Step : 2 Final-Drill the
trim cable routing hole, indicated in Figure 1, in both E-1002 Front
Spars to 5/8" using a Unibit step drill. Make sure to drill the bottom
of the two holes. Drilling these holes dedicates the spars as left and
right, so mark them accordingly. 05/04/08 |
 |
||||||||||||||||||||||||
| Step : 3 Cleco the
E-1002 Front Spar to the E-1001B Bottom Skins as shown in Figure 1 (be
sure the tabs in the skins are directed as shown). Install the clecos
from the skins into the spars. 05/04/08 |
 |
|
||||||||
|
Note: This is my builders log and is not Intended to replace Vans Construction drawings |
||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |