| Empennage kit | Wing Kit | Fuselage Kit | Finishing | Power Plant | Avionics | Paint | Interior |
|
|
|||||||||
|
|||||||||
| 09.03 Elevators |
|
||||||||||||||||||||||||
| Step : 1 Remove the
vinyl from the skins in the area of the tab. Mark the bend line on the
skins as shown in Figure 2. 05/04/08
Step : 2 Clamp a skin between the surface of a work bench and a piece of wood with the bend line at the edge of the workbench as shown in Figure 3. 05/04/08 |
 |
||||||||||||||||||||||||
| Step : 3 Begin forming
the bend by hand using a small, wood block, then finish the bend by
tapping back and fourth along the tab with a flush rivet set in a rivet
gun that has been turned down low. finish the bend to 90° with a hand
seamer. 05/04/08 |
 |
|
||||||||
|
Note: This is my builders log and is not Intended to replace Vans Construction drawings |
||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |