RV BUILDER NET .COM

 

HOMEFAAEAABUILDERS LOGRV BUILDERS LISTVENDORSVANS AIRCRAFT
Page 07.08  Rudder
07.01 07.02 07.03 07.04 07.05 07.06 07.07 07.08 07.09 07.10 07.11 07.12
Step 1: Position the R-1003A Top Rib half on the R-1001-L Skin as shown in Figure 1. Rivet it in place using the rivets called out on Page 07.12, Figure 3. However, leave open the forward three holes to allow the skin to be pulled back for access when attaching the counterbalance weight.  
Step 2: Rivet the R-1003B Top Rib half to the R-1001-R Skin as shown in Figure 2. Use the Rivets called out on Page 07.12, Figure 3 and once again, leave the forward three holes open.  
Step 3: Use the rivets called out on Page 07.12 Figure 3 to attach the the R-1004 Bottom Rib to the R-1001-R Skin as positioned in Figure 3.  
VERTICAL STAB RUDDER HORIZONTAL STAB  ELEVATOR TAILCONE EMP ATTACH  EMP FAIRINGS  BUILDERS LOG

Note: This is my builders log and is not Intended to replace Vans Construction drawings

Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source.