|
RV BUILDER NET .COM
|
| Page 07.07 Rudder |
|
||||||||||||
| Step 1: Rivet together the R-1004A and R-19004-B Bottom Rib halves using the rivets in Figure 1. | |||||||||||||
| Step 2: Rivet the nut
plate to the R1005 Horn using the rivets called out in Figure 1. Rivet the horn to the R-1004A and R-1004B Bottom Rib halves with the rivets shown. |
|||||||||||||
| Step 3: Rivet the
R-608PP Reinforcement Plate to the R-1002 Spar as shown in Figure 2. Rivet the nutplate to the reinforcement Plate and spar using the rivets called out in Figure 2. |
|||||||||||||
| Step 4: Repeat step 3 for the R-607PP Reinforcement Plate (as located on Page 07.05 Figure 2) Using the same rivets and a Additional nutplate. | |||||||||||||
| Step 5: Back rivet (see Section 5F) all the R-1015 Stiffeners to the R-1001 Skins as shown in Figure 2, using the rivets shown on Page 07.12, Figure 3. Riveting tape, which is very useful for holding rivets in place while back-riveting, is available from the Van's Aircraft Catalog. |
|
||||||||
|
Note: This is my builders log and is not Intended to replace Vans Construction drawings |
||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |