|
RV BUILDER NET .COM
|
| Page 07.05 Rudder |
|
||||||||||||
| Step 1: Cleco the
R1015A-L and R1015A-R Stiffeners to the R-1010A Shear Clip as shown in
Figure 1. Make sure the aft end of the left stiffener is positioned on
top of the right stiffener . Final-Drill all the holes common to the shear clip and stiffeners. (the only purpose of the aft most hole in the stiffeners is to keep the hole in front of it aligned while it is drilled. It will not be riveted during final assembly. 12/30/07 |
|||||||||||||
| Step 2: Repeat step 1 for the rest of the R-1015 Stiffeners and R-1010 Shear Clips Shown in Figure 2. | |||||||||||||
| Step 3: Cleco the shear clip / stiffeners assemblies to the R-1002 Spar as shown in Figure 2. | |||||||||||||
| Step 4: Cleco the R-607PP and R-608PP Reinforcement Plates to the R-1002 Spar as shown. | |||||||||||||
| Step 5: Final-Drill all the holes of the shear clips and reinforcement plates which are common to the spar web using a #30 drill. |
|
||||||||
|
Note: This is my builders log and is not Intended to replace Vans Construction drawings |
||||||||
|
Disclaimer : Information contained on this Site may be out of date and /or inaccurate - Please Confirm any important data with a reliable source. |